Technical data

Switching distance Sn*: 10 mm Idle current I0: ≤ 15 mA

Secured switching distance Sa*: ≤ (0,9 x Sn) mm Residual current: ≤ 0,1 mA

Sheet thickness: 0,6...2,5 mm Insulation test voltage: ≤ 0,5 kV

Hysteresis: 3…20 % Short circuit protection: yes / clock pulse

Ambient temperature: 0…+60 °C Current drop at Ie: ≤ 1,8 V

Temperature gradient: ≤ 0,4 K/min Wire breakage / reverse polarity 

protection:

yes / complete

Storage temperature: -25…+80 °C

Operating voltage: 10…30 VDC Communication protocol: IO-Link

Residual ripple: ≤ 10 % Uss Output function: 4 wire, normally open, PNP

Signal delay: ≤ 180 ms Output 1: switching output or IO-Link mode

Standby delay: 300 ms Output 2: switching output

Operating current Ie: ≤ 100 mA

*The given switching distances are valid if the installation instructions are observed and a ferritic steel sheet with a sheet thickness of min. 0,8 mm to 

 max. 2,5 mm and a size of min. 50 x 50 mm is used. 

 Other parameters can cause a reduction of the switching distances or incorrect function of the sensor!

IO-Link

IO-Link specification: V 1.1 Frame type: 2.2

IO-Link port type: Class A Minimum cycle time: 8 ms

Communication mode: COM 2 (38,4 kBaud) Function pin 4: IO-Link

Process data width: 8 bit Function pin 2: DI

Switching point information: 2 bit Maximum cable length: 20 m

Status bit information: 5 bit Included in SIDI GSML: ja

Technical data

Electrical connection: connector, M12 x 1 Vibration resistance: 55 Hz (1 mm)

Cable: ? 5,2 mm, white, D12YSL9Y-OB, 

PP, 0,2 m, halogen-free

Shock resistance: 30 g (11 ms)

Protection class: IP69K, except in the connector area

Wire cross-section: 4 x 0,34 mm2 Operating voltage display: LED

Material

Body material (introducer): steel

Body material (sensor): composite